<sup id="nxtn5"><ins id="nxtn5"><small id="nxtn5"></small></ins></sup>

        <em id="nxtn5"></em>
        <em id="nxtn5"></em><delect id="nxtn5"></delect>

          <div id="nxtn5"></div>
          <menuitem id="nxtn5"></menuitem>

                    <em id="nxtn5"><span id="nxtn5"></span></em>

                      <div id="nxtn5"></div>
                      <em id="nxtn5"></em>
                      <div id="nxtn5"><tr id="nxtn5"></tr></div>
                      <dl id="nxtn5"><ins id="nxtn5"><thead id="nxtn5"></thead></ins></dl>
                       
                      Home  |  About ANYI   |   Products   |   Service + Support   |   Testimonials   |   Expertise   |   Contact   |     
                      Standard Reference
                           Artifacts
                      Precision Step Gauges
                      Swivel Support
                      Module masters
                      Gauge blocks
                      Slide Calipers
                      Digital Calipers
                      Dial Calipers
                      Vernier calipers
                      Digital Scale Units
                      Depth Gauges
                      Digital Depth Gauges
                      Dial Depth Gauges
                      Vernier Depth Gauges
                      Height Gauges
                      Digital Height Gauges
                      Dial Height Gauges
                      Vernier Height Gauges
                      Micrometers
                      Micrometer Heads
                      Outside Micrometers
                      Inside Micrometers
                      Depth Micrometers
                      Indicators
                      Thickness gauges
                      Indicators
                      Special Calipers
                      Special Designs
                      Accessories
                      Clinometers
                      Stands
                      Data Interfaces
                      Surface Plates
                      Others
                      You are here: Home >> Expertise

                      Expertise

                      How to Read a dial Caliper

                      Dial caliper is a handy and versatile measuring tool. It can measure I.D, O.D, Step and depth. Parts of a dial caliper

                      Clean the measuring faces before and after measurement.Close the jaws and check that the indicator points to "0" on the dial face.If caliper doesn't zero, loosen the bezel clamp screw and rotate the bezel to the "0" position.Tighten the bezel clamp screw to fix the "0" position.

                      Dial graduation of .001" and .100" in one revolution for dial caliper of inch system.

                      Dial graduation of 0.02mm or 0.01mm and 2mm or 1mm in one revolution for dial caliper of metric system.

                      For example, a measurement of 15.43 millimetres would be obtained by reading 15mm on the main scale, and then adding 0.43mm as determined by the dial(as shown in the image).

                      Inch Dial calipers are read in a similar fashion.

                      Note: When using either a metric or inch dial caliper, smaller readings than those graduated may of course be obtained by visual interpolation between graduations.

                       

                      [ << Back ]          

                       
                       
                      CopyRight © 2009 Anyi Instrument Co.,Ltd All Rights Reserved

                      甘肃快三开奖结果今天